Here are my latest fluid paintings. I used a lot of color and finished them with resin.
Painted Coasters – Set 2
Okay, the wait is over. The presents were wrapped, shipped, received and opened. Now, I can share them on my blog. Below is a set of coasters I made from my mom. I did a pour painting on top of 4″ wood tile.
They are Finished
Yes, in August I poured these painting. Yes, in November I finally pour resin over these paintings. Now, they are ready to be hung or given away as gifts. No, I am not giving them away.
I did not realize that this painting appears to flow towards the center, until I took a picture of it.
This painting look awesome under a black light. See..
And, this painting looks like it could be a fish.
Fluid Painting to Mandala
This painting was done on a 5″x5″ canvas. It started out as a pour painting, but the blue paint took over the painting. After it dried, for about a week, put a mandala on top of the fluid painting using metallic acrylic paint.
Stand For Fluid Painting
Fluid Painting can be messy. You pour paint over the canvas and it drips over the edges. What a mess! I am not a clean freak, just a person working in limited space and I need my table to draw and do other things. So far, I have limited myself to 4″ canvases, and I have a 3D printer sitting right next to my work table… I decided I would design and print a stand for my pour paintings.
The maximum print size of my Ultimaker 3d printer is around 8 inches, width and length. The height can go up to around 12 inches. So, this project was perfect.
The catch basin is 5″ square, or in my design world 127mm, and 1″ (25.4mm) high. Just in case different colors dropped from the different edges of the canvas, I divided off the catch basin and add drain notches. It didn’t need it, but I placed pegs to hold the stand, and divided off this compartment to keep paint off of the stand. It took around 11 hours to print.
The design was done in Tinkercad and export as a STL file. The file was imported into Cura and where a .gcode file was made. I used the “normal” setting because the “fine” setting indicated it would take 23 hours to print. Therefore, some warping occurred because of the setting and because I select not to add a Brim support.
The stand was also designed in Tinkercad. It is 3 inches high. The break in the structure allows for air to flow under the canvas. It took around 4 hours to print.
The notches on top of the stand, allows me to put some other type of support under the canvas to lift off, in case I want to reuse the stand before drying is complete.
The finished product.
The colors, yes I used Color Shift paint by Folk Art and grab the black and 4 other colors.
Ok, some of the holes leaked. The center dividers should have been larger and I did not pour out of the basin as I expected. I do not know if I am going to tweak the design and reprint it or not. Probably.
I did get a cup (one ounce) out of the basin. It should go nicely with another pour.